After some research, the problem seems to be the ASMedia SATA Controllers. Aside from the typical problems that occur, i have the problem that when booting Ubuntu, i get an "ATA8.00: STATUS DRDY" error. So, i tried installing Ubuntu along with Windows 10. I'm not using a custom DSDT for this motherboard and I've attached my ist if anyone has some insight on either cards.Before anyone says anything, this lies in-between Windows and Linux, and i am not exactly sure where i should go with this, but as it is a driver/firmware issue that i most likely will need to fix over/with Windows, i take this up here. When I use AHCI_3rdParty_eSATA.kext that SATA device is not recognised at all in the system profiler. So not sure why it's preferring the 1062 entry over the 1061 since both are present in the kext. And reading the chip itself on the card it says ASM1061. When I use AHCIPortInjector.kext the SATA device is recognised in system profiler as an ASM1062. I've attempted using two kexts (attached) AHCI_3rdParty_eSATA.kext and AHCIPortInjector.kext I haven't tested the internal ports as I don't need these. However, I cannot get any drive to be recognised in the eSATA ports. System profiler sees the card like all the others as a "Generic AHCI Controller" with AHCI version 1.20 supported. I've switched the jumpers (not sure which position is the 1,2,3) so I've made it so that one internal and one external will operate to test the card. Now the second ASMedia controller I haven't been able to get to work. I know it automatically worked OOB for my NVME2 drives connected to the motherboard, But to enable Trim on an SSD 860 EVO I needed to submit the terminal command: Is this a possible AHCI version firmware issue? Is booting ever possible from these controllers?ģ) TRIM was disabled in system profile. the Maximus doesn't recognise it as a startup option. I imagine this could and should be a newer version? 1.2 or 1.31? If it should be updated, is this something only able to be flashed from a Windows OS?Ģ) It can't be used as a boot option. However, a few things don't seem perfect.ġ) the AHCI version is 1.0. Speeds seem good (350R/400W on an SSD 80R/W on a 5400 HDD) The 1st Marvell actually works OOB in Mac OSX. However, I wanted to add eSATA ports for some older drive enclosures I own, and some extra internal SATA ports as I've used all the SATA ports on the Motherboard. The hack is running stable no issues on 10.4.2 with an i7 8700k ASUS Maximus X Code as iMac 18,3 2 Internal/ 2 External Ports (selectable by jumpers) 4 Internal Ports.Ģnd runs off the ASMedia ASM1061 chipset. Okay So I have two PCIe controller cards, both 3rd party, unbranded from eBay.ġst runs off the Marvell 88SE92xx chipset.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |